The Teradek Cube is a hardware H.264 encoder that streams directly to Livestream over Wi-Fi, 4G, or Ethernet connection.
Teradek provides a walkthrough of the Cube setup here.
We highly recommend installing the latest version of the Cube Firmware. The latest version is available for download here.
Setting Up the Cube
To get started using the Cube, connect the Cube to your computer using an Ethernet cable (or to the same network as your computer). This will allow you to configure your Cube and enable it to be located on the network. Connect a camera to the Cube, then connect the Cube to a power source and wait for it to boot up.
The next step is to configure your Cube depends on which version of the Teradek Cube you have. Newer versions have a built-in LED display in which you can toggle to the Cube's assigned IP address. Enter this IP address into a web browser to access the Teradek login page.
Older versions of the Teradek Cube will need to access settings via the TeraCentral App. Once your computer and Cube are on the same network, launch the app to configure your Cube.
Click on the Video Setup tab. You can adjust Device Settings and Encoder Settings as you need to. To setup your stream to Livestream, click Stream Settings.
On the Stream Settings page, set the Stream Mode to Live Internet Streaming.
Under Service Provider, select The New Livestream.
In the fields that appear below, enter the email address and password associated with your Livestream account.
Once logged in, choose your event from the dropdown menu. You can also choose whether or not to notify your followers when you start streaming.
When you are ready to start broadcasting, click Go Live. The Broadcast Status will indicate that you are Broadcasting and you can click on the Event Link to view your stream.
Select if you want your video on demand to be published right away (Post), saved in draft mode (Save), or not saved at all on the Livestream platform (Delete).
When your event is over, click Stop Broadcast. If you selected Post, your video on-demand will appear under the Posts drawer on your event page.
To update Cube to the latest Firmware, go to http://teradek.com/pages/downloads#cube and download the latest firmware.
In the Cube’s web interface, click System and select Firmware Upgrade.
Click Choose File. Select the firmware update file. Then click Upgrade.
Do not unplug Cube during firmware upgrade and reboot process!
Cube LED Function Info